Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I run LMS 2.6. I am having an issue with end devices on some 4503's not being discovered. My 4506's run the same IOS and the same configuration and are listing all end devices. I checked cdp in the switches and all see their neighbors, but in Device ...
We have Ricoh MFP printers on our network that users authenticate into to scan documents that are emailed. We set up WOL and when we add the command on our switch "ip forward-protocol udp 40000" WOL works, but it seems to break the MFP printers. User...
I am having a duplex mismatch on faste trunk uplink between a 2950 and 6500. The 2950 auto neg at full/100, the 6500 auto neg at half/100. I tried adding the command "duplex full" on the 6500 interface and drop connection. This is my interface config...
I have a 3550 switch that is linked to a 4507. Occasionally the link will go into err-disable mode on the 3550 side. It's intermittent, sometime it won't happen for 2-3 weeks, sometimes it will happen twice in a week. I have had this happen before to...
I am trying to apply access-lists to deny any traffic from other vlans into my voice vlan. I do, however have to allow traffic to/from the DHCP server and the CCM and Unity servers which reside on another Voice subnet. This is what I have applied. My...
That seems to be the problem. The RW snmp is there and I did an edit device credentials, but when I do a credential verification report, under the Read Write Community column it comes up "No Value to test". RW configured on switch the same as the oth...
