Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Team, Is it possible to perform a traffic shaping or priority on Cisco 2130 with the FTD image.I cant find any other documentation then rate limiting.If not is it possible to accomplish that task if we run an ASA image on it? Appreciate you input...
Hi, I was unable to find any documentation giving out information if there is a QoS support on Firepower 2100 Series when using ASA image on it.In our current scenario we have Cisco 5500-x in routed mode with 60+ subinterfaces without hair-pining.In ...
Hi, We planning to deploy about 110 c9200 switches.Is there any Cisco management solution for centralized management?We would like to have the capability to reconfigure multiple ports at the same time. Assign them to a VLANs manually etc and change i...
Hi RJI, I'am very pleased with your reply, unfortunately i could not see anything but Rate Limiting in this article. We would need to prioritize VoIP and other sensitive traffic in front of the rest of the traffic.
Thanks Balaji. Lets just make sure i am on the same page.To be honest the cost is not that important in this specific case. We had a demo with a Sales man which said that DNA cannot manage individual switchports via GUI like we normally do in Meraki ...
Thanks for your reply Balaji, Would our engineers be able to change switchport configuration via GUI on per port\interface basis ?I know that we can run CLI commands thorough the DNAC but is there a graphical way of doing that? Thanks a lot.
