Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,My incoming DSCP value 24 packets are getting remapped...I'm not sure why. Here is my config :class-map match-all ef-traffic match ip dscp efclass-map match-all cs3-traffic match ip dscp cs3!policy-map voip class ef-traffic police 100000 80...
Hi,Can someone tell me what the effect of having multiple ip helper-address commands on the same interface is ?Do the broadcasts get "load balanced" to each of the IP's in turn, do they get send to the second IP if the first is down or do they just g...
Hi All,I know this topic has been covered earlier but nobody seems to of given a definitive answer.Almost all of the documentation I can see says that a switch in VTP Client Mode does not store any vlan info into it's NVRAM.My testing in the lab indi...
I am trying to setup AUTOINSTALL on a catalyst 2950. I have been successfull but I am slightly confused.I am creating a DHCP reservation on my Windows 2000 DHCP server for the switch that I am autoinstalling. After many failures whereby the switch ...
Thanks for your help everyone, but I now understand whats going on.I was mis-interpreting the meaning of the stats from "show mls qos interface x/x/x statistics""DSCP incoming" appears to be traffic coming from the device into the interface."DSCP out...
Hi Mark, thanks very much for your reply.I have just tried setting the uplink port (from the switch to the core) to trust DSCP, it makes no difference.Would this make any difference? Doesn't each port have it's own egress queues, so therefore the res...
Hi,Nobody has answered my original question !!!!!What is the effect of having multiple ip helper-address commands on a single interface?Is it that broadcasts get sent as directed unicasts to ALL of the IP's listed on the ip helper lines ALL of the ti...
Glen,Thanks for the clarification.To clarify again : The original broadcast will get sent as a directed unicast to both of the addresses specificed by the IP Helper-Address commands?Thanks,Ellis
