Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear NetPro user, I have a question regarding underrun and overrun on ethernet interfaces.I am currently looking into application performance at a customer site. A single Catalyst 6509 is connecting a dozen Catalyst 3550's and 3750's through 2 port e...
NetPros,I hope this is the appropriate forum to post issues regarding ASDM.I have a problem with ASDM 5.0(2) running on ASA 5510 with PIX version 7.0(2).I added an access rule, applied it and later removed the rule. I used the building blocks to crea...
I encounterd a strange sitoution. Since I upgraded switch stack from 12.1(19)EA1D to 12.2(25)SED last thursday I am seeing unicast converations from other hosts on my port.No SPAN is currently active. I tried setting the port back to its defaults, ho...
For a while three routers where connected through DMVPN hub-and-spoke tunnels.On the central router split horizon was disabled to distribute routing information accross the tunnels to the remote site which is like the central site running EIGRP.The c...
I am looking for a solution to connect three branch offices to central office.Requirement is to utilize existing DSL service based on RFC 1483 routing with AAL5SNAP encapsulation.I have the following in mind:- CO: use existing 2651 with WIC-1SHDSL-V3...
Hi Justin,My suggestion is to append the "extendable" command to the end of your static NAT entry.ip nat inside source static tcp 10.1.10.11 80 70.91.###.157 80 extendableRegards,Leon
All software configuration guides and command references can be found on Cisco Documentation Site <http://www.cisco.com/univercd/home/home.htm>This link will take you to the Cataylst 3750 Software Configuration Guide for release 12.2(25)SEE, "Working...
Hi Michael,I can't tell from the configuration why the network slows down when switch A and B are directly connected.What I do noted is that the core switch is the root switch of vlan1, hence the spanning-t priority command. In case the bridge-id of ...
If you have two servers that need to be available from the outside on port 80, you'll need two public IP addresses.In case of webservers serving the same content you can use various features such as slb to load balance between servers. Another non-Ci...
WIC-1ENET is not supported on 2600-series. There are no NM options either. You can however create sub-interfaces and use a switch to create multiple segments.HTH--Leon* Please rate ALL posts.
