Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an ASA5506-FTD-K9. I renewed my Threat Defense license recently. Now the 5506 doesn't see or accept the new license. When I renewed the supplier created a new contract number. Should this make a difference? The service level is FTDLO. The lic...
I am trying to configure an ASA5506-FTD-K9 to use an address on the inside i/f as NTP server. However, the box fails to communicate with the server. My understanding is that a static route cannot be configured on the inside i/f. I also assume that th...
I recently purchased a 5506-X FTD firewall and am having difficulties enabling outside-inside traffic. I want to allow OpenVPN traffic (port 1194) . I opened port 1194 on the outside i/f as shown in the attached screen shot. I then tried a packet tra...
Cisco support fixed the problem. The problem was my fault because I didn't supply all the information about my smart account and virtual account to the supplier whom I was dealing with. My excuse is that I only have one smart and one virtual account ...
Will do. I appreciate your moral support. I must say that Cisco licensing is just about the most baroque institution I’ve encountered in high tech and I’ve been around a long time
That solved the problem. Thanks very, very much!! Just so I understand: the problem was that when static rules are searched a match on either source or destination selects the rule? In my case, the inside1_2 rule was chosen because it appeared earlie...
