Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a DS3 unframed connection between Tokyo and HK. At tokyo end it is a Cisco 7200 (PA T3 + card) and at HK it is Cisco 3845 (NM-1T3/E3 card). I am having CRC / input errors on the serial interface on Tokyo side. No patterns, just burst of errors...
Please compile the MIB "CISCO-RTTMON" on your NMS. Then enable "snmp-server enable traps rtr" on your router, running IP SLA / RTR. You can send traps for jitter, rtd or other vialoations on IP SLA / RTR tests by setting a threshold and configuring "...
Rx measured from HX in front of CPE (including coax cable) is around -4.5 dBm. Wanted to know whether this falls under Cisco's acceptable range for a PA-T3+ DS3 adapter ....
