Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Has anyone tried to run IOS IPS in a 7206vxr NPE-G1 router? How's the performance (max throughput) like? How much CPU increase after turning on the IPS?Thanks.
Hi Guys,Was told that Cisco recommends not to configure a link to 100% priority/bandwidth traffic (ie. no best effort traffic on the link). I can't seems to find the relevant doc that explain this. Can someone help to explain if it's true?Thanks.
I'm looking into extending the mpls network by NNI with other SPs. For scalability reason, most dosc recommended to use Option B (MP-eBGP for VPNv4) for the Inter-AS connectivity.However, it seems that most SPs that i talked to prefer Option A (back-...
Hi,I am trying out Internet access for MPLS, using NAT at PE. The PE is connected to a internet gateway, and 2 CEs.Everything works as per expected when different private ip is used in the CE. However, when overlapping private ip is used in the CE, t...
It works after i upgrate to 12.3(13)T. However, the 'show ip nat trans' does not give the details NAT anymore.. Are you using 12.3(5a)B4? Any idea when there will be a stable release?Many thanks for your help!
Found out that there is this error when i turn on 'debug ip nat detailed'. Could it be an IOS bug? i'm running 12.3(11)T3.05:22:09: NAT*: Can't create new inside entry - forced_punt_flags: 0
Thanks for your help. I'm getting similar debug results as yours. However, I'm not able to ping vrf to a public ip, traceroute vrf is fine though.#traceroute TEST1-VRF 203.y.y.1 1 203.x.x.1 4 msec 0 msec 4 msec 2 203.x.x.7 0 msec 4 msec 0 msec 3 2...
Thanks for your reply.My initial test actually did not put the fa0/1 in VRF. However, after the return traffic from public is nated back to private, the global routing table has no knowledge of the vrf routes.From a cisco example, there is a need to ...
