Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
You cannot use LDAP accounts directly for Management purpose.
However, you can use Radius server as the Proxy and the backend with LDAP server.
Regards,
Divya
Hi,
I assume the AP model as AP1852 and it is on CAPWAP mode
on the WLAN to enable dot1x, you need WPA2+AES and 802.1x under Layer2 security configuration.
This is the ideal config.
Please let us know if you have different requirement.
Regard...
Hi Satya,
When the WLC is in HA SSO, then there is no special config required on the AP level. This is box level Redundancy. Meaning, one of the WLC will acts as active and the secondary will remain Standby until the failover happens.
On the Lice...
AP "Gig 0" interface is referenced as Ap port.
AP uplink will be connected using Gig0 interface and you have to configure that Switch port as trunk with native VLAN defined. There is no need of any config on Aux port.
Follow this work around:
Workaround:Set AP port as trunk. Then the AP AUX port will belong to the native VLAN (hence the traffic will go through untagged).Configure a native VLAN on your switchport to place the AUX port in the VLAN you need.
Rega...
