Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to monitor the status of the communications of the CAM & CAS. In looking at the MIB, there's an alert count, but this never increments when the CAS goes offline. Originally I was going to use SNMP traps, but there's only a trap sent when t...
With the 4 port fxs/did module is it possible to use a buttset to test the port's operation when running in DID mode? I've tried and the vpm debug, show invalid input when digits are sent.
It was a HA pair for 105s. This is what was being logged. There was no power issues, assumed the box was crashing. It's only passing SD-WAN traffic. Feb 14 08:01:19Sterling DC - Primary Device bootDevice bootreason: power event or other
Installed 18.208 on a few MX85's with out issues, but the MX105 was a desaster, boxes were unstable and rebooting every 20 minutes or so. Rolled them back to 18.107.2
@clandmar We had a customer reach out to us yesterday, employee left and now the Y cable is missing, maddening that there's no spare part cable that can be ordered.
Doesn't show in the event logs, as the layer 7 rules are not logged. Packet capture would show it, if you did it post firewall (i.e. you would not see the packets).
