Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have got 2 Nos. of 3550-12T & 1 2950T for testing, below are the configuration for 3550. created vl 2, 3, 4 & 5.3550T-Main config.-----------------------------------------------vlan 2 ip address 192.168.10.253 255.255.255.0standby 2 ip 192.168....
i hav got Cisco 3550-12T, in that i hav created VLAN 2,3,4 & 5. now my requirement is VLAN 2 can communicate all VLAN's, where VLAN 5 should only communicate VLAN 2 & vice versa & VLAN 3,4 should only communicate VLAN 2 & vice versa. how do i procee...
Hi, I have got 1 3750(main) & 1 3550(standby), i had given the HSRP commands also, now when 3750 goes down 3550 will take care of the network client switches & servers, now for testing i have switched off the 3750, 3550 is taking atleast 30 sec to ...
Hi, We have got Cisco 6509(Main) & 3750(Standby), 6509 has got L3 card & HSRP is running & 3750 also running HSRP, i know that 6509 & 3750 should hav connectivity each other while running HSRP, so that even if 6509 fails automatically 3750 becomes ...
Thanks ankur, 4506 provided by vendor (as standby) says that its a L3 device, i tried prooving that, but he is not accepting, now i hav got the proof in cisco discussion form.ultimately we need to configure o hav l3 module for inter-vlan routing. no...
Hi gpauwen, i tried the 1st option which you have mentioned, with that also there is no difference, only this is the port started blinking very fast apart from that no changes in that, also you told me try that "spanning-tree vlan 2 forward-time 4 ...
I hope Jumbo frames might be enabled in 3750. once if the jumbo frames are enabled it affects all the ports & you cannot enable jumbo frames for individual ports. by default all 100Mbps NIC will supports only 1500Bytes,where as 1000Mbps NIC will supp...
