Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I need to create a site-to-site VPN tunnel using IPSEC established over the Internet between two offices. The offices belong to two different companies. I was given a range of 16 public IP addresses. One of these IPs is used on the ISPs router...
Hello,Can anyone refer me to any recent (2006-2007) official reports by trustworthy organizations (i.e. gartner) that indicate the Cisco supperiority in the networking world (routing, switching, security, etc)?I must justify my purchases through thes...
Hi all,I have a 1712 router at my office where I have it configured to accept IPSEC VPN connections. I noticed, however, when I try to connect using VPN client from within my office to a remote office with a PIX, through the 1712 router, I fail. Obse...
Hi all,We have a fairly large hub-and-spoke network of about 200 routers and increasing. The hub is a 7206VXR router with an SA-VAM module installed and c7200-ik9s-mz.122-15.T15.bin IOS. The spokes are 1720, 1721 and 1603 routers using software encry...
Kanishka,It turns out you were right! I made the changes remotely last night and then tried to test my tunnel through the SDM. SDM gave an error. I kept the changes however and today I tried the tunnel by starting my actual application... it worked l...
kmalhotr and kaachary,Thank you for the response but unfortunately neither suggestion solved my problem. I have run the VPN TEST through the SDM and it showed the NAT test as successful, along with everything else, except the peer connectivity. As I ...
George,Thanks for the reply. Are you suggesting that the problem is on the remote PIX configuration and not on the IOS VPN router?I only have a single public IP and therefore I cannot use another IP for NAT. Upgrading to PIX v7 is not a feasible opti...
I have a similar issue and I created a topic in the forum as well. No answers yet. The only difference is that my VPN client is behind a router with IPSEC/IOS. When I try to initiate the VPN session from my LAN through the IOS/IPSEC router to the rem...
I resolved similar problems after I totally uninstall the antivirus and firewall protection I had on the PC, installing the VPN client and then re-installing the antivirus/firewall software again. I had Panda antivirus...
