Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We're moving into a new location that already has a wall hung rack and we can't switch it out. The rack is about 20 inches deep and there are only front mounting locations (the back of the rack is bolted flush to the wall). We'll need to get extens...
Everything was fine until last night. The VPN was passing traffic just fine. I have not made any changes to the PVN recently (I even compared the configs to weeks ago, and the VPN portions are exactly the same). Where can I start looking? I've re...
Hello all,We're using Cisco 7962G phones (latest firmware) at end user's homes. Our ASA 5510 (IOS Version 8.4(3)) is configured as a Phone Proxy and we have a CME running on a Cisco 2851 ISR (IOS 15.1) on the back end.The phones register just fine a...
Since the back wall has plywood on it, we ended up screwing the rear rail brackets to the wall and resting the switches on the patch panels. It's not ideal, but at least they're supported toward the front and back. We did get two shelves for the MX25...
Thank you for this. show crypto ipsec sa showed me what I needed to figure this out. Someone else helped me read the output as I wasn't sure what I was looking at. Here's what they told me:Looking at the ASA ipsec statistics.access-list Remote_spli...
