Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Has anyone run into issues with Prime Infrastructure (specifically v:3.0) discovering devices in VSS?
I not only receive alarms from my other monitoring tools during the discovery of my 4500-X (VSS) but it appears that PI doesn't discover the modules...
The best way to accomplish this would be to have your internal controller anchor to another controller located in you DMZ. This would allow you to choose whatever SSID you want and have its traffic virtually terminate outside of your trusted network...
sdavids, Were these APs converted from Autonomous to LWAPP? If so read below:If you configure an access point to use a static IP address that is not on the same subnet on which the access point's previous DHCP address was, the access point fall...
Just my 2 cents: Adding APs to support additional users is fine as long as you do a site survey to make sure that this will not cause interference. Remember that B/G only has 3 usable channels, thus the more users you have connected per channel an...
A Few Questions:Are your running RRM?What is your Beaconing Period set to for the network (A,B/G,N) you are attempting to connect to?What code are you running on the WISMs?
