Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I currently have the following access list in my Cisco PIX 501 & 506s:access-list nonat permit ip 192.168.53.0 255.255.255.0 10.10.0.0 255.255.0.0 access-list nonat permit ip 192.168.53.0 255.255.255.0 10.110.0.0 255.255.0.0 access-list nonat permit ...
I need some helping setting up my VPN Concentrator so that our remote sites can access devices at our new data center.Here's how things are set up.Data Center: 10.110.1.0Corporate: 192.168.0.0 & 192.168.1.0Currently devices in 192.168.0.0 & 192.168.1...
I setup LACP on a Cisco 3750-G and a 3Com 4500 switch. I created Port-Channel 1 and ports 1 & 2 are in this Port-Channel. My question is this:When I type in show int port-channel1 it shows the speed as 1000mb. I thought it would show 2000mb?Or is LAC...
I have some question about Link Aggregation in regards to 3Com and Cisco.I just bought a 3Com 4500 48 port switch (3CR17562-91) for an IDF.I have a Cisco Catalyst 3750 and a Cisco Catalyst 3750-G in my server room.3Com uses LACP (Link Aggregation Con...
What would you guys consider to be around a normal amount of Transmit Discards on a switch?I'm asking this because we use solarwinds and under High Errors & Discards it's showing pretty much all my HP Thin Clients, Computers and some printers with di...
Ok so I took 5/1 and 5/2 out of port-channel1 to tried to create a new port channel3 and assign it an ip address like its talking about in the article. But in my 3750G it doesn't allow me to assign an IP address to my port-channel3.Why do i need to a...
Here's the commands I used:interface range gi5/0/1 - 2channel-group 1 mode activechannel-protocol lacpswitchport trunk encapsulation dot1qswitchport mode trunkIs that not right?when I do show interfaces for port-channel1:Port-channel1 is up, line pro...
Here is what Cisco website says:3750switchstackA(config)#interface range gigabitethernet 1/0/4 - 53750switchstackA(config-if-range)#channel-group 1 mode active!--- This creates port channel 1 and configures it with LACP.3750switchstackA(config-if-ran...
I took 3 ports and check them. They are at Full Duplex Speed 100So i set speed and duplex to auto and i'll see what happens.Whats strange is it is all the ports on all the switches pretty much.The network person before me set every single port to the...
