Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,Since I upgraded my Cisco Spectrum Expert to 4.0.68, I have been detecting some strange type of interference during Spectrum analysis sweeps, the environment were I did those sweeps is not yet active for Wlan clients, so I am not aware if...
Hi,does anybody have a good detailed document (beside the configuration guide) regarding the upgrade of the WCS, what kind of problems can we expect..., tips & tricks.... this would be very appreciatedthx
we did an site survey for a warehouse in witch we had 20 ap's (1050) foreseen, we made a channel map with power adjustments, once the installation was complete we enabled the RRM feature on the controller, this feature should fine tune the rf enviore...
whith deployment guide do we need to follow, the deployment guide for wireless location services uses a high density of access points (interference) and the VoWLAN deployment guide uses a low density of access points?will VoWLAN work in a wireless lo...
Hey Kayle,thx for the additional info, i did not had the time to do some more research...... hoping to do so in the near futureanyway if you encounter some more info please let me knowmany thx
Hey Kaylethx for the reply, as far as I can understand, it's explained how CleanAir see's this type of interference, 3500 series access points are deployed in the coverage area were I did the spectrum sweep.the interference sources are classified as ...
thx for the tip mhd@oticon.dk i will see if we can check this, i suppose that i will need to enable the feature before i can check the cli, the problem is that this is an remote site.what if it defaults to zero, what's the solution..... firmware..?
we have the same problem with the 7921's, we disabled WMM, all phones are working fine for now.... but unfortunately don't know the issue with WMM is....cheerz
