Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
On previous ISE versions, when I want to move endpoints from group a to group b I always used an .csv file.When we went to 3.4sp3, now I get the message 'Out of 102 endpoints presented, 0 endpoint(s) have been imported successfully, 102 rows have xss...
Well found in community that 2.4 to 3.x should work with restore.I am running ISE 2.4.0.347 and want the config be restored in 3.4 and get the message:ISE24/admin#restore Backup_cfg_data-CFG10-250209-1700.tar.gpg repository <repository> encryption-ke...
Hello, I've a new 9200 switch and want to add SSH to the Management interface.Normaly I use SVI, but for this I want to use the Mgmt interface.SSH is enabled, key generated. Gateway for Mgmt-vrf is correct, I can ping the switch on the Mgmt interface...
Looks like the behavior of the import is changed. Jatin gave me a good hint.I did remove the ' (quote) from the column Identity Group, now it works.Thanks for the hint.
Thank you BW,But this link is for import users, I'm importing endpoints.Actualy I'm moving endpoints from group a to group b. I always do it by an Excell, first column is mac, 3rd column is the group.
I'm using ISE 3.4sp1When copy a file to tftp, it asks for a username/password.dummy/dummy will doWhen I try to do this by kron it gives the message 'element does not exist'How can I copy a file using kron on ISE ?
If you first disable the subs and thereafter the master, the commands stays visable.If you want it clean, first enable cdp, then remove the subs (by enabling it) and then disable cdp againRegards,AvR
