About ingi

ingi · 04-09-2005

Hi.I have a 2811 ( CO ) with a 4-wire SHDSL interface connected back-to-back over a leased line to a 1841 ( CPE ). I have the line-rate set at 4608kbs and it works fine with no errors on the SHDSL interfaces.I then connected my lap to the 1841 f0/0. ...

ingi · 04-10-2005

The command "line-rate auto" isn't an option on the routers, 2811 or 1841. I must enter the line rate value.Attached is the output from "sh contr dsl 0/0/0" and the config. The DSL config is the same on both except for line-term, CO on the 2811 and C...

ingi · 04-10-2005

Hi.Thank's for your reply. I'm using the WIC-1SHDSL-V2, http://www.cisco.com/en/US/products/hw/modules/ps3129/products_documentation_roadmap09186a00802c4afc.htmlS4_1841#sh int atm0/0/0ATM0/0/0 is up, line protocol is up Hardware is DSLSAR MTU 4470 ...

Member Since	‎04-09-2005 02:31 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	3

User Statistics

User Activity

Only 50% bandwidth using 4 wire SHDSL back-to-back

Re: Only 50% bandwidth using 4 wire SHDSL back-to-back

Re: Only 50% bandwidth using 4 wire SHDSL back-to-back