Check the configuration of the interface on the router and the port/interface on the switch. Make sure that Duplex and Speed match on both devices. Usually a high number of collisions/errors on an interface could be a duplex mismatch.I would certainl...

If your Cat6k has an MSFC (router) you can session into the module, or telnet if there is an ip address assigned to the management vlan. Once telnetted into the MSFC you can use the command "show ip arp" and use the IP address of the workstation in q...

I used to have problems with some 3500 XL's rebooting when closing out HyperTerminal on a console connection. The solution was to upgrade to 12.0(5.3)WC(1)

here are some commands you can try:set prompt Console>set length 24 defaultset logout 20You can also enter the "session" command to access the MSFC (router) and uses IOS commands, which has a line con 0 interface.Good luck

As far as FEC is concerned the channel will always look like one logical link (STP will see this as one link as well) when traffic is routed. If one link drops convergence to the other links is transparent (ms in time)Are these being configured as re...