Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
What are the basic configuration commands to enable MLD based IPv6 multicast on an interface??? I have the following config : ipv6 multicast-routing (globally) interface GigabitEthernet1/0 no ip address negotiation auto ipv6 address 2000:104::1:1/128...
7200VxR(config-if)#vlan-range dot1q ?<1-4094> First VLAN ID in rangeIs this VLAN Limitation on 7206 VXR???I need to have 4096!!!Some info on this would definitely be rated
Hi All,I need more information on DSCP values for Traffic Class in IPv6. Unfortunately, RFC 2460 doesn't have any information regarding this. It says "Detailed definitions of the syntax and semantics of all or some of the IPv6 Traffic Class bits, whe...
Hi..I am a bit confused in Implicit and Explicit null labels. The RFC Says as follows :IMPLICIT NULL LABEL:This label value is only legal at the bottom of the label stack. It indicates that the label stack must be popped,and the forwarding of the pa...
Hi Friends...Thanks for the needful.I do understand the PA-2FE-TX would serve my purpose but isn't there any Port Adapter (PA) which comes with four ports on a single PA instead of having 2 PAs i.e 2 PA-2FE-TX since I need 4 ethernet ports???
Agreed Paresh...Let's consider a frame that enters the VPLS domain. The scenario here would be something like this. CE1-->PE1-->P1-->P2-->PE2-->CE2A frame with VLAN tag enters the PE1 Ingress router. PE1 router is going to strip off the SOF,Premble,t...
Hi Paresh..I think IOS not an issue since I did a mistake while initial config. As it asked for "whether u want to enter initial configuration yes/no" I chose the yes option. I should have chosen the NO option and should have come out of it, but it w...
