Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,We have set up a IDSM2 version 4.1 on a Cisco Catalyst 6500 switch.We have configured it using SPAN on specific vlans and if we run a port sweep, we can see the alarms on the IDS viewer.It is possible to stop any attack by dropping packets/...
We have Cisco Call Manager 4.0.1 and a H.323 gateway connected to PSTN.We want to add a fax server. Will the brooktrout TR1034 card with the IP interface work in our environment ?I have read that for IP network connectivity, the TR1034 digital T1/E1...
Hello ,Customer has three buildings which are interconnected through ethernet. At main building we have a 6500 catalyst switch which interconnects to a 3500 catalyst switch at one building and to a 3750 catalyst switch to the other buidling. Is it po...
Hello Pete,What we did is to configure the brooktrout adapter to speak h.323 sipv2 with a cisco router. We got the config of the 1034 from brooktrout and we defined a dial-peer for incoming faxes in the voice gateway. In the gateway, we defined sessi...
Hello Yavuz,Thanks for your answer.However, we do not want to connect the TR1034 analog or digital T1/E1 port to a router. TR1034 has also a ethernet port and can connect to the same LAN as Callmanager. This way we want to offer Fax over IP.Fax serve...
Hello Amit,On the same building which 3500 is installed, we have three Cisco Catalyst 3560-24PS-S switches. I guess that if you use 3560-24PS-S instead of the 3500, everything would work. From what you are saying I understand that the RSPAN feature o...
