Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have following configured on the PIX:user user1 password cisco1 privilege 1user user15 password cisco15 privilege 15aaa authentication telnet console LOCALaaa authorization command LOCALI used both user1 and user15 login(via telnet), there's no dif...
"Prior to Cisco IOS Release 12.3(6) and 12.3(7)T, for such spoke routers to participate in a DMVPN network, they had to use IPSec tunnel mode. " is stated in the following doc:http://cco/en/US/products/sw/iosswrel/ps1839/products_feature_guide09186a0...
I have following configured on the PIX:user user1 password cisco1 privilege 1user user15 password cisco15 privilege 15aaa authentication telnet console LOCALaaa authorization command LOCALI used both user1 and user15 login(via telnet), there's no dif...
Thanks, it's very good doc.But if you look at the config examples in the UniverCD, they always use MTU 1416. Just wondering why.http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122t/122t13/ftgreips.htm#wp1062127
Gfullage, Thanks for your reply.If I only have 2 interfaces, I think to inspect the traffic as it comes in or to inspect as it goes out should be same. But if I have more than 2 interfaces, inspect as the traffic goes out will inspect all the traffic...
Hi Marcabal,You said: "If the switchport is configured as an access port for a single vlan, and the span is configured to monitor multiple vlans; all of the packets will be seen by the sensor, but there will not be any vlan headers. The sensor won't ...
