Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have AS5300 with IOS 12.3(13b). My customer uses proprietary SIP Pabx. Standard call works fine, bud there is a problem with call transfer. After the call is put on hold and unhold on PABX side, AS5300 does not connect back to UDP port of cus...
Hi,is there SNMP MIB for getting voice call resources ?I can display utilization of my AS5300 DSP and DS0 with command:show call resource voice statisticbut I need to check it by SNMP application.Thank you.Vladimir
Hi,is it possible to define a rule for incoming voip dial-peer matching based on the source IP address of originating VOIP gateway ?I need it for differentiate outgoing POTS lines based on the source gateway. Any ideas how to do it ?Thanks,Vladimir
Thanks, this is the right solution I need.Which dial-peer has higher precedence: one matched by carrier-id or the one matched by destination pattern ? I'm trying to use both and it seems that the destination pattern matching has higher precedence, bu...
