Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HIDoes h323 inspect handling configuration where h323 setup comes outside to inside or inside to outside, but GW where media stream is negotiated is placed behind the third ASA interface ? See attached topology picture.rgds,Ismo
HICan I run SIP and H323 in the same AS5400 ?If so can I run those on separate NICs ?Call scenarios:sip--->FA 0 AS5400 --->PSTN h323--->FA 0 AS5400 --->PSTNor sip--->FA 0 AS5400 --->PSTN h323--->FA 1 AS5400 --->PSTNMany Thank,sIsmo
Hi I get Following error, when I import activate configuration from our MGCsThat nasty error comes out after I deploy two trunks, where bouths are 123 ts.number of trunk elements=>80 colProp number of colums-> 80Java .... etc...Thaks advance,Ismo
Below are simple example, where prefix 7 or 8 are added to using that feature. access-list 1 permit 1.2.3.4 0.0.0.255 access-list 2 permit 3.4.5.6 0.0.0.255 voice source-group 1234 access-list 1 disconnect-cause invalid-number translation-profile inc...
HIYou can use source-ip based dial-peer to using voice source-group, access-list and translation rules.Example:voice source-group customer1 access-list 50 translation-profile incoming 50voice source-group customer2 access-list 40 translation-profile ...
HIYou can use voice source group feature with ACL and some prefixes, Below is an example of such an configuration..access-list 1 permit 1.2.3.4 0.0.0.255access-list 2 permit 3.4.5.6 0.0.0.255voice source-group 1234 access-list 1 disconnect-cause inva...
