Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i have the IOS converted software from VxWorks and i currently have software version 12.2(11)JA3 loaded and i want to upgrade to the newest version or at least a later version so that i can enable WPA. when i try to use the HTTP upgrade page within I...
I just tried to upgrade my firmware to IOS in the AP1200, using the steps provided by the Cisco website. And now i can't access the AP using IE and the IP address. I used to be able to access it fine when I had VxWorks, but since the upgrade I cannot...
i'm trying to upgrade from version 11.54 to the newest version available and can't seem to find the correct documentation from such an old version to the newest one. 11.54 has a completely different layout than v12. The only problem is, is that i can...
Ok, I'm getting closer. Sorry to keep asking questions, but I'm a newbie at this and was wondering if I could get it working. With the archive command at the end "tftp://192.168.185.1/" what do I enter in after the IP? 192.168.185.1 being the TFTP se...
Scott, Thanks for the pointing me in the right direction there. But, I'm still not sure how to use that command. It could be that my AP is not hooked up to our company network. I am not able to do that due to the protocol. So, would I still be able t...
I think the problem is that the IOS software did not install fully and/or it is now inoperable. What do I do in this situation? I need to find a way to put the AP into recieve mode using HyperTerminal, but I can't seem to do it and send the IOS upgra...
Ok, thanks for the info. I remember reading that, but I wasn't sure if someone has gotten around it before. So, now I need to get the IOS software to work. Any suggestions on some changes that have to be made so that I can access the AP with a web br...
