After upgrading the rommon and ios on a part of VSS (2x6800-X-LE), one of the module in a 6800-X-LE is showing as PwrDwn in the module status.
sh module switch 1=========Switch Number: 1 Role: Virtual Switch Standby---------------------- -----------...
OK, so the next option is RMA.
When the new module is inserted, will it download automatically upgrade the rommon, if the version on the new is lower than the one in system currently? or should the upgrade rommon required again?
Some more logs after reseating the module and reset and power disable/enable:
*xxx xx:xx:xx.xxx: %OIR-SW2-6-INSREM: Switch 1 Physical Slot 1 - Module Type LINE_CARD removed*xxx xx:xx:xx.xxx: %OIR-SW2-6-INSREM: Switch 1 Physical Slot 1 - Module Type L...
Rebooted the switch using redundancy reload peer and checked the logs on console. The above message was not there.
redundancy reload peer
Reload peer [confirm]
Preparing to reload peer
System Bootstrap, Version 15.1(02r)SYS4, RELEASE SOFTWARE...Curr...
Regarding the FPGA upgrade for this particular model of switch and modules, the following info is found in the cisco. The modules used in the switches are not in the list, so I believe it is not applicable in the case as none of the linecard used are...
