Cisco ACS didn't support MS-PEAP until version 3.2.I ran into the same issue, once I upgraded to 3.2 it worked.Here is a link to the release notes for 3.2 where MS-PEAP support is listed under new features.http://www.cisco.com/univercd/cc/td/doc/prod...
There are step by step instructions in the Readme file. You can download the readme file the same place you got the patch:http://www.cisco.com/pcgi-bin/tablebuild.pl/wlan-sol-eng Hope this helps.
I believe your boot variable is pointing to the wrong location, it should be pointing to cisco\c4000-k8.7-2-1.bin. It looks like the image file is inside a directory called cisco, that's why it doesn't see it when you boot the switch. Set the boot ...
If you want to run an IOS above 11.2 you need to replace the RP with a RSP7000. Documentation for the RSP7000 can be found at:http://www.cisco.com/univercd/cc/td/doc/product/core/cis7000/routeswi/25617rsp.htm
To use a flash memory card you must be using IOS 11.0 or later boot roms. What I've been doing is having the router pull the latest IOS from a tftp server. Yes its not the best solution, but it lets me run the latest IOS without having to get new ...