Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've been posting here before regarding CSS and NAT'ing and how our web servers just log the VIP address of the CSS.Now it turns out after a talk with our programmers, we can't use NAT at all because the backend servers will deliver services based on...
I just replaced two servers which were behind the CSS LAN with two brand new ones. The old servers were never actually in use, but services and content rules were created.I entered the same private IP addresses for the new servers, 192.168.1.11 and *...
I just configured two web servers behind a CSS11501 box to box cluster. Both web servers has two interfaces active, the secondary interface on both are on a private 192.168.1.0/25 network so they are on the CSS's LAN.What is a bit of an issue to us, ...
This is probably basic, but how satisfactory is this http load balancing method:service http-1 ip address 192.168.1.10 protocol tcp port 80 keepalive type tcp active service http-2 ip address 192.168.1.9 protocol tcp port 80 keepalive...
I know this is not exactly related to the CSS boxes and this might be a dumb, newbie question, but how would people go ahead in this scenario:Two or more servers behind a CSS box-to-box cluster, all servers use the same NFS NAS box for storage, and t...
Thanks, I think I'm almost where we can close this thread as solved.I'm not sure if I understood correctly what you meant by if a server needs to open a connection, but I accessed one of the servers which now are behind the one-armed CSS, and success...
Thanks Gilles.I read the list of advantages and disadvantages.However the only disadvantage I can see, is that the CSS yelds lower performance since it has to shuffle inbound and outbound traffic on the same interface.For instance: "When using this c...
Okay, before I/we delve too deep into the problem, I just did a test with setting the default gateway on the servers to the public (e1) IP address of the CSS, changed the IP address in the services to the public IP addresses of the servers, and the s...
gdufour, no, no combination with trunk on e5 worked so I switched it off. Yes, e5 is connected to a HP switch. The default vlan on the HP switch is 1, the firewall is connected to another HP switch (these two are directly uplinked, but are strictly l...
Thanks Gilles (took some time to get back to this issue because of vacation and other rushed assignments at work).I do have a question, say VLAN1 which is the CSS WAN interface has address 192.168.10.5/24.VLAN2 which is the CSS LAN is 192.168.1.4/24....
