Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 3560 Layer3 switch with two VLANs. VLAN10 IP address 192.168.1.1 and VLAN 20 IP address 10.10.10.1I have most of my clients and file server on VLAN 20. I am able to map the drive to server without any issue. However I have a few client on VL...
Thanks to all that helped.I have found the issue IT is not with my VLAN or Routing. The Microsoft server had routing turned on. I disabled routing on the server and I am able to connect just fine.Thanks
Sorry, I sent the old config. All the same except the IP address scheme.interface Vlan10 description Mgmt VLAN ip address 192.168.1.1 255.255.255.0 ip helper-address 10.10.10.5 ip authentication mode eigrp 100 md5 ip authentication key-chain eigrp 1...
I get error message " Network Path Not Found"The weird thing is. If I take a client that is on VLAN 20 I can map over the my other server on VLAN 10. At IP address 10.10.10.5
