Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We just had our Sonet turn up, and we now have 2 ethernet handoffs connecting to of our buildings.I have been working with Vlans and have created a VLAN domain, a server, and the rest of my switches are clients that belong to the domain.Everything on...
I want to back up my IOS on a cisco 2621 router, but when I look at the directory I do not see any flash memory, nor can I find the IOS file in any directorythis is what I have on the router TDS_Primary#dir ? /all List all files lex: ...
According to what I've read the encapsualtion dot1q command was implemented in version 12.0 I have 12.2 but when I create a sub interface the encapsualtion command is not availabloeWhat am i missing !!!Here is the show version info from my routerCisc...
I've read through a wealth of information but haven't been able to discover the solution.I have 2 2950 switches which have been wiped clean. They are being used in a lab setup.I enter the command switchport mode trunk on FE-0/1 on both switches. When...
I cannot seem to get multiple Vlans to run on my 2950 switches.We need to be able to maintain our management Vlan1 and also allow internet traffic on another vlan and workgroup traffic on a 3rd Vlan.Everytime I turn on one Vlan it shuts down the alre...
I just openned up one of my cisco 2600's with the problem I've documented.There was flash memory installed but obviously it wasn't recognized.I removed the flash meory that was installed and placed a spare 8mb strip I had laying aroundSure enough I w...
I figured it out, I used a - instead of a _ in my VTP server domain nameDOH !!!!I was rushing around yesterday trying to get this up, which usually leads to typos eh !!thanks
InterestingAny examples on how to do this ?My problem might be with the 2948G switch which is located on Side A and is directly trunked to my VTP Server. It isn't showing any of the Vlans I created.
Thaks for all the suggestions. As soon as I get the opportunity I'm going to open these routers up and look at them.If there is nothing obvious I am going to boot an IOS from TFTP and see what that does.
Exactly, there is no flash memory shown when I use the show ver command, the dir ? command or the dir flash: command. No I have not physically taken the cover off of the router to see if there was flash memory installed. All the rest of my 2600 seri...
