Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Experts, We have multiple branches which communicates with one of the vendor for services. Right now we are in process to have all the branches over a single MPLS line to communicate with HQ. Everything was fine until we ran into an issue. One of...
Hello Experts,
As question from interview panel, how to clear some lines from device logs without clearing entire logging. I am not sure how to remove some lines, i have seen if we want to clear, it will clear entire logs in IOS, NXOS, ASA logs. J...
Hello Experts,
We are installing some default and static routes in our core nexus switch, which further need to be redistributed in EIGRP instance running on the core. I have configured three default routes with different AD value and other are ...
Hello Experts,
I have two ASA 5545-X boxes installed and both the boxes has SFR module installed though the license has been expired and we are going to renew it soon. Both the ASA boxes have multiple contexts and are fail-over pair.
The issue...
Hello experts,
Just curious to know if we can have management port as SPAN destination port, though i have gone through the Cisco docs but could not fine the answer. I did not see management port as destination port for any session. Please let me...
Thanks Jon for the response.
Let me put the config which i had on my UK-Core.
ip access-list extended AUS2Vendor
permit ip AUS/24 vendor/32 (being specific server IP-sddress)
Route map AUS2Vendor
match ip address AUS2Vendor
set ip next-hop recursiv...
Thanks Marvin, yes i agree we should upgrade the code now and we have in out plan for next year. When you say
"Your configurations will be lost unless you are using FirePOWER Management Center (previously known as FireSIGHT Management Center or Defen...
