Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I'm testing the following scenario:[HostA(Lo0 172.16.1.1 DefaultGw 192.168.0.1) int addr:192.168.0.10/24] --in-- [EPG - BD(192.168.0.1/24)] --C-- [L3OUT (EIGRP)] ---- [Router(LAN 0.0.0.0 EIGRP)]I have host route 172.16.1.1/32 in EPG pointing t...
Hi,Everything is described in detail here: Configure Leaf or Spine Replacement in ACI.Although in new versions of APIC, before You disconnect the old switch, You should use the "Remove from Controller" option directly. You can also use the "Remove fr...
Hi,It works the same for me. "ALL" shows data from the last 24 hours. Moreover, the "ALL" option is not described in the "ACI online manual".regardsAndrzej
Hi,According to information from Cisco APIC Troubleshooting Guide, Release 3.x and EarlierYou can use cli:fabric xxx show hardwareInformation about fiber optic inserts can be obtained e.g. like this:fabric xxx show interface transceiverormoquery -c e...
Hi,Presentation "Cisco ACI with VMware VDS Integration", slide 9: "APIC Initiates Handshake and Login with VC on Port 443 via OOB or In-Banddepending on preference". This is a standard TCP connection.regardsAndrzej
Hi,Can you draw your topology? Are both L3OUTs in the same VRF?Can you show:fabric <LF_ID> show ip route vrf <Tenant:VRF>fabric <LF_ID> show ip ospf neighbors vrf allRegards,Andrzej
