I have terminals that boot up from a disk and obtain IP from server via DHCP. Had 2950 switches and works a treat. Replaced switch with 3750 not in stack and cannot get this to work. IP address appears as incomplete in ARP on router momentarily.
Now I have another problem, in that there are two types of NIC cards in the tills.One type is 3com, the other is realtek. The 3com dont work on the 3750, but the realtek does. How can i find out if there is a compatibility issue with the 3com one?
Hi all thanks for your suggestions.I have now got the terminals / tills to boot across the 3750. I have a flat vlan 1. When you set a port to switchport and switchport access vlan 1 on a 2950, it shows on the sh run as switcport mode access and when ...
DHCP on same VLAN. Only using VLAN1.ip helper on router even though same subnet. Have tried with and without.Not tried to hard code yet. Would the trunk config make a difference if the trunk was not being used. The client and server are on the same s...
Hi, thanks for the reply.I have routing OFF.I have portfast on. Its as if there is something that is on by default on the 3750 that wasnt on the 2950. (or indeed off).
