Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have a question concerning call manager express.Is it possible to connect a router with two different E1 PRI from two different service providers. Additionaly there must be a possibility to distinguish between outgoing calls which must use pri 1 ...
HiI have a ASA 5510 with a CSC-SSM and i have special question concerning the CSC features.I would like to use a different set of CSC features for two types of traffic.--> Standard Workplaces (Source Subnet 1), URL blocking, threath/virus protection-...
HelloI have to implement a VPN connection (PIX to PIX with IPsec) from a branch office to the headquarter. There will be some type of Internet connection (DSL or leased line with public IP's) at branch office. The VPN config is straight forward but t...
Hi allI have troubles with a PIX 515-E VPN config. The PIX does a site to site VPN with another PIX which works fine. I have to add a dialin VPN for mobile workers. My configuration shows like below. I can dialin using the VPN Client V 4.0.1 and I re...
Hi all. I have a PIX 515-E (OS 6.3) doing a IPsec tunnel with another PIX (remote site). That works fine. Now, my question is how to establish additional tunnels to different peers from/to this PIX. Has anyone a config example for that?ThanksPatrik
HiThanks. But that was not my question. I know the features of CSC-SSM with plus license. The goal is to differentiate between different source traffic types and apply a URL blocker or not.After intense reading of the technical references i know that...
ThanksThis solution doesnt meet the security requirements. In this case the router outside the firewall connects directly into the company net over isdn. The ISDN Router must stay behind the PIX in a high security level network segment. A solution co...
HiI added the isakmp nat-traversal, but it's still the same. Can it be that there is a problem due to the existing site to site VPN? I made a test configuration with a lab pix before which worked properly. The difference was that there was no site to...
Thank you. I tried this but the NAT 0 command can only have one ACL assigned.My current config:access-list ACLVPNTAG permit ip 172.17.x.x 255.255.252.0 10.0.x.x 255.255.252.0 logip address outside 212.x.x.x 255.255.255.192ip address inside 172.17.x.x...
