Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to configure server load balancing in IOS on a 6509 using the NAT or directed method. I believe that I am missing one small piece of the configuration, but I cannot figure out where. Pings to the three addresses all respond, but telnet ...
I am having a similar issue. The access switch is a 3560 running 12.2(25)SED1 going against ACS 4.1. Reauthentication is disabled in the port configuration and the workstations are configured with the AuthMode=2 and SupplicantMode=3 DWord registry ...
And the solution is...After contacting TAC, it is now working. I did not enable mls flow ip full in order to get it to work. By creating a NAT pool for the clients, and applying this client pool to the serverfarm, the IOS SLB took care of the serve...
Yes, they are directly connected to this switch. I have disabled server nat, but once disabled, any requests to the virtual IP are not forwarded and subsequently time out. If server nat is enabled, requests to the virtual address get natted and for...
