Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am using VPN Concentrator 3030, with image 4.1.7.D. I configured remote access & LAN-to-LAN VPN on this concentrator. Now because of my remote access users have a problem to access VPN through NAT/PAT, I enable a NAT-T. (In Configuration | Tunnelin...
Hi, I am try to use site to site VPN through VPN concentrator 3030 at both side. Site A has a lan Ip address 192.168.1.x/24 and my side IP address is 172.16.1.x/24. Now when source packet from 192.168.1.x subnet come to my VPN, I want to NAT it to 1...
Hi, My internet router are connected to two different ISP.On my server and with both ISP routers, BGP is running. I am using PAT to access the internet. Now I configured two default route on my router, one for each ISP. Now if both ISP's link are co...
Hi, I am using LMS 2.2 and I configured all the devices to send snmp trap to LMS.DFM is configured for all the devices. Now when the devices restart, it's send a cold start trap to DFM but I can't find coldstart trap in DFM monitoring console. I wan...
Hi, Presently I have a 6513 with MSFC running IOS image. I configured 25 L3 vlan on cat 6513. ALl the vlans are using vlan IP address as a default gateway. Now I want to install FWSM on this switch, I want to use 1 vlan for outside, 2 dmz vlan and o...
Hi, This is a typical cold DR site setup which normally only used in Disaster time only. The only two option available ti test DR site system are as below.Disable the communication from main siteEnforce the NAT & ACl at DR to main site link router....
Hi, This is a tricky solution but it's must work.Go to your ethernet interface's connection properties. Select TCP/IP propertiesSelect Advance in TCP/IP PropertiesIn Advanced TCP/IP Setting, change the Interface metric from 1 to 2. Apply the config...
Hi, Can you check your Ip address when you are connected to Broadband-Internet connection? What is your mail server IP?.Waitng for your reply.Regards,Mustafa
Hi, Monitoing interface used to send the tcp rests. Command & Control interface is used for Shun.Your Switch which is being monitored with either SPAN or VACL capture should accept incomming packets on SPAN or VACL capture port. Otherwise your tcp-r...
