Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I know that Cisco Nexus 5548UP is trusting by default DSCP or cos incoming his ethernet interfaces.
Could you tell me how to configure untrust on other interfaces that don't need to be trusted because no ToIP servers in there ?
I can't find an...
Hello,Could you provide me with password recovery procedure for a Cisco SF 300 switch. I can't find it in documentation.Thank you very much for your help.Regards.A.S
Hello,Could you please me tell me if a Cisco Catalyst 2960X-48TS-L is able to do IP static routing and inter vlan routing and if there ara limitations ?Thank you for your help.
Hello,I need to know if i can design VSS using one Cisco 4500R with Sup 7E and a Cisco 4500R+E with SUp 7E ?I need toknow also if Supervisor 7E is compatible with 4500R chassis ?Thank you.
Is it possible to configure loadbalancing of ldaps with end-to-end mode (encryption from end to end) on ACE module ?And if yes, do i have to use a special script for health checking ?
Hello,Thank you for your answer.But i have read this note in the link you sent :Note Do not select a routing template (sdm prefer routing) when the switch is running the LAN base feature set. Although visible in the command-line help, the LAN base fe...
Thank you Dragan for your response. But the link shows that only 4507R-E or + are compatible with sup7E, i didn't saw the Cisco 4507R ? Is sup 7-E compatible with exactly 4507R ?Thank you.
