Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to configure a pix firewall 506 E SW(6.3 (5))to run DHCP server for its inside hosts. Below is the config. For some reason, hosts say they are unable to contact the DHCP server to get leases. Any help on this is highly appreciated.Inside ...
Hi,I have configured Extension Mobility in CUCM 6.0. Device is enabled with EM and User Device profiles are created. Peculiar issue is that user is able to login to the phone successfully using credentials. The phone comes back normal but without the...
Hi,thanks for the quick reply. When I applied the command dhcpd enable inside, it automatically changed the command to dhcpd address 192.168.1.10-192.168.1.100 inside. Will run a packet capture and see if it helps.
Just now finished call with TAC and they are suggesting for a ES patch to be applied on the CCM 6.0 boxes which they think might fix this issue and also lot of other bug fixes. Let me try that and see if it works.
Carl,thanks for the quick reply. I did face this issue earlier and I did try restarting EM and CCM service. Did not work. But when I rebooted the entire cluster, the problem got resolved. The issue is, with the same user id I am able to login to anot...
Hi,CRS documentation specifies that teaming is not supported. I have seen recording work fine with Supervisor desktop. I read somewhere in Cisco documentation that not all desktop NICs support recording. You may need to check on that part as well.Is ...
