Hi All, and thanks for your help. I have 2 ASA5512x setup for Active/Passive failover. Port 0's on each firewall are connected to 1 Catalyst 2960 XR ( at factory default ) Port 1's on each firewall are connected to a separate Catalyst 2960 XR ( at ...

HI All Thanks for any and all help. I have a port channel that works fine when set as follows on a Catalyst 3750 Stack. interface Port-channel9 switchport trunk encapsulation dot1q switchport trunk native vlan 2001 switchport mode trunk switchport ...

Hi, I am looking for some help with this issue.We have multiple customers that have request that we perform remote service that we connect to through anyconnect. Due to the various levels of comfort with change and technical abilities at the customer...

How do I configure a vpn where the internal network at each end of the tunnel are using the same addressing.aka net a Inside Network 10.0.1.0 /24VPN between site a and site Bnet b Inside Network 10.0.1.0 /24Not even sure how to ask the question to lo...