Hi,To get the radio up you'll actually have to untar the full package (c1240-k9w7-tar.124-10b.JA.tar) as this has the firmware for the wireless:AP: tar -xtract tftp://x.x.x.x/c1240-k9w7-tar.124-10b.JA.tar flash:/The workaround we had was specifically...

Hi,In case anybody else gets stuck like I did, here's the procedure we eventually knocked together for recovering our locked out 1240AG AP's:Recovery of Cisco 1240AG APThis procedure tested working 14/02/08 with an AP with the default WLAN controller...

Hi,Eventually ended up going the looooong way round. Returned the unit to autonymous mode and then used the upgrade tool etc. to take it back to LAP. Associated with the WLC no problem and is now back under control.Problem arose due to the WLC and LA...

Hi,Thanks for your replies, guys.I've tried resetting the device (1242AG) by holding diown the mode button. It shows:button pressed for 20 secondsprocess_config_recovery: set IP address and config to default 10.0.0.1process_config_recovery: image rec...

Hi,I am having exactly the same issue. Is there no way of forcing a LWAP to it's default 'out of the box' state without requiring the WLC, do you know?Regards,Steve.