Hi:What is the most common implementation with SP's regarding this?Do SP's commonly use dot1q tunnel + l2pt on the ce intf and q-in-q on the intf to other PE's?It would be nice to know the practical implementation.Thanks.
Hi Jaya:Yes, you need to redistribute static under eigrp config too (even though you have it under BGP).If you run more than one PE-CE protocol on the same PE that connects the 2 CE's you have to redistribute the routing protocol b/w them in addition...
Hello Martin:Would you mind if you can elaborate on the 1st command: "mpls ip encap explicit-null"?I looked it up on cco and it says that if you have mpls enabled on a router and you enter this command, an error msg. occurs.I tried it on my 7200 and ...
Hi:"Unfortunately" you HAVE to use the default-information originate cmd with BGP in addition to the static route.:-)Same goes for Ospf.....A simple default static will not get redistributed !!Regards.
Hi Swaroop:For those of us who have no access to 7600's n a lab environemnt, can the 7600's be emulated using DynaMips in a laptop?I also have access to 2 7507's running rsp-k91pv-mz.122-25.S9.bin with 3640's as CE'sI would like to learn/test out VPL...