Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,I have a Cisco Catalyst 4507R (core switch), I want to implement inter-VLAN communication within my 5 subnet (ex: vlan 12, vlan 17, vlan 20 etc). Can you please guide me on the exact configuration on how to do this. Any help will be gr...
Hello,Is there a way to block certain websites (ex: myspace.com, friendster.com etc) using ASA 5510. I know that you can use regex to do this but I'm not so sure about the exact commands. Please help.Thanks.
Hello experts,My network topology uses the ff: cisco devices:Cisco ASA 5510 as my VPN and Firewall device, it goes to my Layer 3 Switch which is Cisco 4507R that connects all the Cisco 2950 Layer 2 devices. I have 4 subnet 10.223.12.x, 10.223.13.x, 1...
<p>Hello everyone,</p><p>I have an ASA5510 and it's been running fine for a while now. One thing I notice is, on the ASDM Firewall view, I notice sometimes that the Interface facing the Internet (Outside interface) its showing ( ) n/a - config out o...
Hello experts, can you please help me configure or direct me on how to properly configure (need some Technical Documentation) for my CSC-SSM20 security module that I installed with my Cisco ASA 5510. Any help will be greatly appreciated. Thanks again...
Do you need to enter encapsulation type (like dot1q or ISl) after you enter the VLAN ip address? Thanks again.ex:interface vlan 12 ip address 10.1.12.1 255.255.255.0encapsulation dot1q 12 no shut --chie
marwanshawi,First of all, thank you for the quick response. Is it possible not to run VTP domain and client and just create the correponding VLAN's. I know that ip CEF is running on the 4507 switch and ip routing doesn't seem to appear in the running...
Hi, with the 4 subnet that I mentioned, is that mean I can create a maximum of 4 VLAN's and give one VLAN over the other priority (ex. HTTP traffic or IPSEC traffic). The default gateway for all the VLAN's will be the ASA. Is this possible. Thanks ag...
