Ok HSRP gives us the ability to have redundancy in our network, if your single link (cable) goes down what would be the point of that configuration? You need an additional link going to IOU1 and SW3 for a true redundant topology, better an additional...
I hope I am understanding your question, module 5 and 6 should be your supervisors. all the Te ports can be used to my knowledge. Typically the standby will be in a redundancy role of standby supervisor, SSO mode and status standby hot. Since the ide...
HelloHow I do it is by enabling SNMP on the device, in SW go to add node enter the hostname or IP choose Most Devices: SNMP and ICMP enter your strings click next and select the resources you wish to monitor, you can get very granular from the device...
