Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
I am not sure what is happening here.
Ok first my setup, i have Cisco ASA 5515X, ASA software version 9.5(1) ASDM software version 7.5(1)90.
I have 2 new webservers on a dmz and i wish to forward incoming connections to them.
The internal servers...
Hi
My knowledge on VoIP is very limited, so i am looking for some help and guidance on migration of 2801 to 2901 routers.
We are upgrading a number of routers from Cisco 2801 to 2901/K9, the 2901 have already been bought/delivered and left for me to...
HiI bought 4 Cisco IP Phones CP7942G for use with an Asterisk server using SIP, as i don't have Calllmanager and have an existing Asterisk setup.I know this has been discussed many times, but i am finding it very hard to find an easy consistent way t...
HiI have a Cisco ASA 5515-x with IOS 9.1.My problem is i have 6 interfaces (1 failover, 2 dmz, 1 outside, 1 inside and 1 spare) and I need to create new:DMZ - for new LAN (subnet).Outside interface - for new Site to Site VPN peer, there is a requirem...
Hi Ankita,
Thanks for the quick reply.
These are the current nat rules in place which work to allow ports 80, 443 and 8443 through the firewall.
nat (outside2,dmz1) source static any any destination static public_address webserver service http_1 ht...
Hi Mohit,
The existing 2801 routers do have PVDM's installed, but they are not the same, the 2901 slot is to big for the PVDM in the 2801.
No problem though, i know what to order now.
Many thanks for your help.
Chris
Hi Mohit,
Many thanks for the reply, and information regarding correct parts.
I will check the existing router today and see if it has the pvdm, might save me some time and money if it has.
@Aman, thanks good to know, it will be permanent licenses ...
I finished the move, slightly different, but was still all manual as predicted and confirmed by Jouni:I created 3 sub-interfaces on the spare interface for DMZ's.Used a switch to VLAN them and connect to FW.I copied all the existing DMZ rules to the ...
Hi JouniThanks for such a quick response.The reason for 2 separate public addresses is more a management decision beyond my control, so just have to go with it:-(Thanks for the information, i was thinking it would be a manual process, but had to chec...
