Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Wondering if there is away of sending KVM information through a Cisco LAN Switch?Using KVM to Ethernet (and at the other end the opposite) converters?CheersCraig.
Hi,I have a Catalyst 2924, with a 2914 expansion module (4-port).How do I configure these 4-ports to obtain DHCP addresses from a '2wire 2701HGV-W' 4-port router?Thank you in advance.Craig.
Hi,I have a CISCO Catalyst 2924 (2900 XL), which has a WS-X2914-XL-V module.I would like to connect my 4 port Wireless Broadband router to the 4 ports on the X2914, then have 4 VLAN's using the 24 ports of the main switch.I would like the 4 ports on ...
Hi,I believe you have to turn the router into a bridge.I am experiencing the same issue, where I have a server, switch and Notebook. I configure the Ethernet port on the Server, Switch and Notebook to be in the same range.I allow the Notebook's wire...
The 2914 is a 4-port expansion module in a Catalyst 2900 switch. The Switch itself is the 2924, with 24 ports.Does this mean there are two switches in one?I'm not sure if I can specify IP addresses for the router itself. Currently it deals out DHCP...
