Hello,I just purchased a Cisco AP from eBay and had a couple of basic questions, Is this AP upgradable to IOS from VxWorks? If so will this upgrade enable 802.11g support as opposed to 802.11b.Thanks In Advance.Tony
Hello,We have a new 4510R that needs to have the failover configured from one SE to the other SE. We've setup the trunk ports on the active supervisor on Gi1/1 - 1/2 and need to set this up on Gi2/1 - 2/2 not sure where to begin. What are the options...
Hello,We've just loaded an IOS image on our 4510R, afterwards the standby SE is diabled and in simplex mode, is there a way to bring it online and copy the new IOS image over to the standby SE and configure redundancy.Thanks,Tony
Hello,Been looking around for documentation on how to setup a wireless solution or HotSpot for around 100+ customers. Is there a Cisco document that describes solutions as far as how many APs and what type of wireless control center and switches requ...
Hello, looks like this AP has a password set. Is there a way to reset this thing to factory defaults without the password? or is there a util that can do this (the Ap is running VxWorks by the way. I noticed also by looking for a compliance sticker ...
Thanks for your reply, I'm not sure if the radio module is 802.11b it may have the g module. I asked the seller this info but was unable to determine this, I'll find out when the AP arrives.Thanks again.Tony
Found the issue, the IOS version running on Active Supervisor was not able to be copied using the command copy bootflash:image_file.bin slavebootflash:image_file.bin due to lack of avialable space on the standby. I deleted the image from the standby ...