Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I need to computers (on different VLANS) but pointing to the FW to connect via specific tcp ports. I'm getting this syslog message.106015 Deny TCP (no connection) from 192.168.167.64/1433 to 192.168.167.80/1796 flag SYN ACK on internal interface.S...
Hi,i've got two switches connected on stack for production and another for a test network,i connected a crossover cable on port g0/9 of testswich to port g0/46 of NS2.When i do sh arp on testswitch i can see and ping all ips of the other network but ...
Hello, i've got two Catalyst 3950 connected on stack for the production network and another 3950 catalyst for the test network. There is a crossover cable from the Catalyst of test network to one of the production catalyst in order to give them conec...
I attach the switches config.ip routing is enabled in all switches, and ping is ok from hosts on vlan30 to hosts on vlan1 but there are issues like the tcp ports that i dont understand.that's why i said that if the FW is denying the tcp connection i ...
ok,becouse 192.168.165.0 is the internal network, and there is another network on other switch, which i connected with a crossover cable, and so i configured on that third switch an interface from vlan 1 with this 192.1658.165.61 ip, so that the inte...
I've looking at the FW syslog, and i saw consistent message becouse this server on the vlan30 is trying to connect to the other server on vlan1. The msg says Deny TCP (no connection) from 192.168.167.64/1433 to 192.168.167.8071795 flag SYN ACK on int...
