Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We currently have two floors with each floor having a stacked pair of 2960-X and we have a temporary need to add another switch for a new floor while we renovate our building. I was able to get another 2960-X to use but not sure how it should be conf...
I have a 501 that was up and running for a long time we changed ISP setup now have a DSL (netopia router) I changed the ip's of the 501 to the new range (501 and outside route) it worked for a few weeks then stopped.We have a 2950 where each isp goes...
Ok, we now have a DSL line (netopia router) and we had a previously good working RAS setup to our Microsoft RAS server and with the ISP change I just went in and changed the ip addy to the new ones and the RAS vpn no longer works. I am a newb so I am...
Hi, I was not planning to add this as another member of the stack. I was assuming since it will be far away I would just make a Trunk port off interface 48 on the new switch and also on the stack from the floor that is closer to this one. If I wanted...
