Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to upgrade from Cisco Intrusion Prevention System, Version 6.0(3)E1 to Version 6.04(a)E1. The downloads from The Software Download Resource site is in .pkg format. The Configuration guide for IPS says to install image with a .bin.gz format...
I have some events that I would like to stop appearing as incidents in my Mars appliance. Consequently, I've set up a rule to tune the specific event. It is listed in my Drop Rules and is set as active. However, the event type continues to appear in ...
I have a 3750 with 12 SFP ports doing routing at a remote property. I also have a backup T1 connection on a 2821 Router. I need to be able to connect the the gig ethernet RJ45 connection on my T1 Router to a port on my 3750 switch so I can do HSRP. I...
I have a 3750 with 12 SFP ports doing routing at a remote property. I also have a backup T1 connection on a 2821 Router. I need to be able to connect the the gig ethernet RJ45 connection on my T1 Router to a port on my 3750 switch so I can do HSRP. I...
I have a 3750 with 12 SFP ports doing routing at a remote property. I also have a backup T1 connection on a 2821 Router. I need to be able to connect the the gig ethernet RJ45 connection on my T1 Router to a port on my 3750 switch so I can do HSRP. I...
To answer your first question. You will not be able to guarantee you only receive traffic between the two servers. With the configuration you're displaying, you are mirroring all traffic going to and from the specified interfaces to your remote vlan....
To answer your first question. You will not be able to guarantee you only receive traffic between the two servers. With the configuration you're displaying, you are mirroring all traffic going to and from the specified interfaces to your remote vlan....
Interestingly enough, My ASA5520 failed a PCI scan failure this morning as well but it was due to X.509 Certificate MD5 Signature Collision Vulnerability.Cisco released a response:Cisco Security Response: MD5 Hashes May Allow for Certificate Spoofing...
If you are trying to access any of the vty sessions on the switch via a network connection you may want to plug in console and make sure you don't have an ACL blocking your incoming connections. As well as ensure that the ip address is specified with...
