I have pix 525 with 8.03 ios and adsm 6 installed.remote vpn configured fine, cisco vpn client installed fine.but after the connection, I can't access any hosts outside of 10.0.0.x(inside) subnet.I can't even ping my outside NIC 129.2.28.100anyideas?...

I'm trying to setup VPN server into existing LAN and having some problems.let's assume that my network is 129.1.0.0/16 and they are all public IPsbut has a firewall at 129.1.0.1/24and two other existing subnets behind firewall that I have physical ac...

I have client vpn setup on PIX 8.03 with ADSM6 and NAT-T is enabled.This pix is used for VPN only and and all IPs are public except for client who is behind home NAT device.once connected I can only access other machines that are in same subnet as th...

I have following Ports required but when I enabled NAT-T on client side (I think server is ON by default)It can't connect(no prompt for username) just hangs and time out.protocol 50 and 51udp 500udp 4500do I need more?Again, It connects fine with NAT...

I have pix525 with ASA8 with ADSM6 behind layer 2(transparent mode) firewall.I've configured Remote access VPN on this thing and I can connect from home(with NAT-T disabled)all the ip address are public ip except the client from home which go through...