Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Guys,Please am the admin to my Meraki network for my organization. I have setup all users with the domain ID and created a password that was sent to their email. Please I have noticed some of the staffs can't remember the password they changed ...
Hello Guys,I have MX68 and I have two ISP I want to migrate to the WAN 1 and WAN 2. I'm using WAN 2 to connect one of the ISP with a Static IP. I want to connect Starlink to WAN 1. Please I need best practices and steps to configure the WAN 1 and WA...
Hello Guys,I just migrated MX68 to my office network and have only set up the below configuration and noticed the network is slow. Please guys kindly assist where I need to make changes to allow the network flow to be good.Regards,Emmanuel
@jdb1 Thank you so much for the response. Please can you explin more how you mean by " Set the correct bandwidth for wan1 and wan2"?. Presently my WAN 2 allocated 8Mbps bandwidth for download. So I will appreciate more guidance on this. Thank you